ontario regulation 63/01

made under the

ontario planning and
development act, 1994

Made:  March 20, 2001
Filed:  March 20, 2001
Printed in The Ontario Gazette: April 7, 2001

Amending O. Reg. 482/73

(County of Halton (now The Regional Municipality
of Halton), City of Burlington)

1. Ontario Regulation 482/73 is amended by adding the following section:

155. (1) In this section,

“setback” means the horizontal distance between the boundary of a lot, parcel or block of land and the nearest point of any building or structure, measured perpendicular to the boundary;

“storey” means the portion of a building other than a cellar, basement, or attic included between any floor level and the floor, ceiling, or roof next above it;

“storey, first” means the storey closest to finished grade having its ceiling 1.8 m. or more above average finished grade adjacent to the exterior walls of the building.

(2) Despite section 4 and paragraph 3 of section 7 of the Order, one single dwelling, together with accessory buildings and structures, may be erected, located and used on the lands described in subsection (3) if the following requirements are met:

Minimum lot area	0.25	hectares
Minimum lot width	34	metres
Minimum front yard setback	9	metres
Minimum rear yard setback	9	metres
Minimum rear yard setback for accessory buildings and structures	5	metres
Minimum side yard setback
West side	8	metres
East side
First storey portion	3	metres
Second storey portion	6	metres
Maximum building height	9	metres

(3) Subsection (2) applies to that parcel of land in the City of Burlington, in The Regional Municipality of Halton, being part of Lot 8 in Concession II, N.D.S., more particularly described as  Parts 1, 2, 3, 4, 5 and 6 on Registered Plan 20R-13875, deposited in the Land Registry Office for the Land Registry Division of Halton (No. 20).

(4) Despite section 4 and paragraph 3 of section 7 of the Order, one single dwelling, together with accessory buildings and structures, may be erected, located and used on each of the lots described in subsection (5) if the following requirements are met:

Minimum lot area	0.25	hectares
Minimum lot width	30	metres
Minimum front yard setback	9	metres
Minimum rear yard setback	9	metres
Minimum rear yard setback for accessory buildings and structures	5	metres
Minimum side yard setback
First storey portion	3	metres
Second storey portion	6	metres
Maximum building height	9	metres

 

(5) Subsection (4) applies to that parcel of land in the City of Burlington, in The Regional Municipality of Halton, being part of Lot 8 in Concession II, N.D.S., more particularly described as Parts 7, 8 and 10 on Registered Plan 20R-13875, deposited in the Land Registry Office for the Land Registry Division of Halton (No. 20).

Barbara Konyi

Manager
Provincial Planning and Environmental Services Branch
Ministry of Municipal Affairs and Housing

Dated on March 20, 2001.